How To Manually Light Pilot Light On Gas Fireplace. To light a gas fireplace, you will need to locate your pilot light. To ignite a fireplace with an electronic ignition system, just turn the ignition button or press the control panel.
Press this button and you should see the pilot light turn on whenever you turn the gas control to start the gas. The fire should be lit. * if you do not see a red or black spark ignitor button, you do not have a manual ignition system.
Be Careful With This, But Insert The Flame Into The Pilot Light Tube, And The.
Turn control knob counterclockwise to the on. You will need to hold your pilot button for the allotted time that your owner’s manual suggests. Turn the control knob to a pilot position.
Bring On The Heat By First Approaching The Gas Valve And Making Sure It Is On.
Press the fireplace safety pilot control knob down and hold it as you turn it over to the pilot position. According to anderson fireplace, gas pilot lights use about 1,000 btus per hour. After approximately one minute, release the gas control knob.
Release Knob If Pilot Stays Lit (If Not, Go Back To Step 3 And Repeat).
The pilot light is typically placed near the main burner or just below the logs or coals of the gas fireplace. How do you manually light a propane fireplace? Depress the igniter button until the pilot lights.
Always Remove Your Fireplace Glass Prior To Lighting Your Pilot.
If your pilot light does not ignite, wait a few seconds and try. Relighting your heatilator® standing pilot fireplace video. You can turn up the gas at this point, since the pilot is.
While In The Ignite Position, Press Down On The Knob Until You Begin To Hear A Clicking Sound.
These are usually near the floor. If power is actively supplied to your fireplace, simply turn the on/off button, wall switch or remote control to “on” to ignite your main burner. Tap the switch until the pilot light ignites.
